16 GB/IE
Detach the fastening nut
10
from the tap thread
14
.
Screw the short side of the tap thread
14
into
the tap body
24
.
By hand, screw both of the flexible connecting
hoses
8
from below into both of the correspon-
ding hose mounts in the tap body
24
. Under no
circumstances should you use tools to screw the
connecting hoses
8
into the tap. Make sure
that the connecting hoses
8
are running straight
and are not being clamped.
Place the base ring seal
15
into the groove on
the base ring
16
.
Ensure that the base ring seal
15
is positioned
correctly in the corresponding groove.
Place the tap body
24
onto the sink unit so
that the base ring
16
encircles the mounting
hole for the tap.
Guide the plastic triangle
13
, the silicone seal-
ing ring
12
, the transparent washer
11
and
the fastening nut
10
if necessary over the con-
necting hoses
8
from below. When using the
plastic triangle, ensure that the flat side is fac-
ing upwards so that it lies directly on the under-
side of the sink unit when installed.
Fix the tap to the sink unit by hand-screwing the
fastening nut
10
into the tap base from below
until it stops.
Screw the connecting hoses onto the corner
valve on your wall connection.
Make sure that you attach both connecting hoses
correctly to the hot or cold water connections.
After successfully installing the product, turn on
the hot and cold water supplies.
Use
Initial use
Carefully check all connections for leaks after first
use to ensure that they are sealed sufficiently.
Check that the tap is operational. To do so,
swing the tap lever
3
into all permissible
positions.
Note:
the tap is equipped with an LED light. The LED
is lit through an integrated turbine (without batteries).
The LED colour changes automatically based on the
water temperature, thanks to an integrated tempe-
rature sensor:
· up to approx. 32 °C: blue
· from approx. 33–40 °C: green
· from approx. 41–45 °C: red
· above approx. 45 °C: flashing red
Open the main water supply.
Lift the tap lever
3
and swing it to the right or
left to regulate the flow or temperature of the
water.
Hot water:
swing the tap lever
3
to the left.
Cold water:
swing the tap lever
3
to the right.
Maintenance and cleaning
Maintaining and
cleaning the fitting
Please note that sanitary taps require special care and
attention. Therefore, please follow the instructions:
Never clean with petrol, solvents or aggressive
cleaners or hard bristled brushes, etc. These
could damage the product surface.
Dry your tap with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and,
if necessary, mild detergent.
Failure to observe the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the warranty.
Replacing the LED insert
If the LED bulbs fail to light up, the LED insert
20
can
be replaced.
LED service life: approx. 10,000 operating hours.
