Z8F3224 ZMOTION Development Kit
UM029501-0321
USING ZDS-II TO DEBUG A PROJECT
User Manual
16
Using ZDS-II to Debug a Project
Zilog Developer Studio II (ZDS II) Integrated Development Environment is a complete standalone system
that provides a state-of-the-art development environment. Based on standard Windows user interfaces,
ZDS II integrates a language-sensitive editor, project manager, C-compiler, assembler, linker, librarian,
and source-level symbolic debugger to provide a development solution specifically tailored to the Z8
Encore! Family of microcontrollers.
1. Download and install ZDS II using the procedure outlined in
Appendix B. IDE- Zilog Developer
2. If not already installed, install the VCOM USB driver included with the ZMOTIONL400ZCOG_1.0
installation file by right-clicking on the .exe file and selecting
Run as administrator
. This driver is
located in the Drivers folder.
-
Zilog_VCOM_Install.x64.exe: 64-bit Windows
-
Zilog_VCOM_Install.x86.exe: 32-bit Windows
-
The Device Driver will be installed as (Zilog USB Serial Device) in Device Manager under
Ports (COM & LPT)
Connect ZMOTIONL400 Dev Board and PC
Observe the following procedure to connect the ZMOTIONL400 Development Board to your PC. We will
use the ZM_NP_Command project for this example.
Caution
:
Disconnect or turn off the power to the ZMOTIONL400 Development Board before
connecting or disconnecting the Encore! SmartCable or the USB Smart Cable.
1. Ensure that the NP Current Jumper is installed on J9. It should be installed across the centre two
pins, as shown in the following figure.
Figure 11. NP Current Jumper Installed on J9
