Chapter
Advanced Configuration
9
Wreless-G Busness Ethernet Brdge
Web HTTPS Access
If you want to enable https access,
select
Enabled
. The default setting is
Dsabled
.
Click
Apply
to apply your changes, or click
Cancel
to
cancel your changes.
Administration > SNMP
This screen is used to configure Simple Network
Management Protocol (SNMP), a popular network
monitoring and management protocol.
Administration > SNMP
SNMP
To disable SNMP, leave
Dsabled
selected (default) .
To enable SNMP, select
Enabled
, then select the type of
SNMP to use, either
SNMP V & V
or
SNMP V
.
Devce Name
Enter the name of the Wireless Bridge.
Contact
Enter the contact information for the Bridge.
Locaton
Enter the location of the Wireless Bridge.
SNMP V. Username
Enter the username for the SNMP
V3 administrator who will access and manage the MIB
objects.
Authentcaton Password
Enter the authentication
password for the SNMP V3 administrator. The password
must be at least 8 characters in length.
Prvacy Password
Enter the privacy password for the
SNMP V3 administrator. The password must be at least 8
characters in length.
Get Communty
Enter the name of your Get community.
Set Communty
Enter the name of your Set community.
SNMP Trap-Communty
Enter the name of your Trap
community.
SNMP-Trusted Host
Enter the IP address of your Trusted
host. To have the Access Point respond to SNMP messages
from every host in your LAN, enter
0.0.0.0
.
SNMP Trap-Destnaton
Enter the destination IP address
for traps. To prevent traps from being sent to any of your
LAN hosts, enter
0.0.0.0
.
Administration > Configuration Management
Administration > Configuration Management
This screen lets you save the system configuration to
a file as well as restore the system configuration from a
previously saved file.
To save the configuration, click
Save Confguraton
To Fle
, then follow the prompts to save the file to your
computer.
To restore the configuration from a file, enter the name of
the file or click
Browse
to locate it, then click
Apply
.
Administration > Factory Defaults
This screen is used to restore the Bridge’s factory default
settings. When you do this, you will lose all previously
configured settings and cannot recover that configuration
unless you have saved it using the
Configuration
Management
screen.
Administration > Factory Defaults
Select
Yes
next to
Restore Factory Defaults
, then click
Apply
to restore the defaults and restart the Bridge.