![background image](http://html1.mh-extra.com/html/linksys/wet200-wireless-g-business-ethernet-bridge/wet200-wireless-g-business-ethernet-bridge_user-manual_1924741021.webp)
Chapter
Advanced Configuration
Wreless-G Busness Ethernet Brdge
Switch > QoS
Switch > QoS
The Quality of Service (QoS) configuration in this switch
has two parts: QoS Mode and Rate Limiting. QoS Mode
is used to classify and prioritize packets. Rate Limiting
is used to limit the amount of bandwidth used by data
passing in or out of the switch port.
QoS Port Settng
Select the QoS settings for ports 1-5
and the wireless port, then click
Apply Port Settng
.
QoS Mode
Select the desired QoS mode:
Force
Prorty
(default),
Trust 80.p
,
Trust IP TOS
, or
Trust
IP DSCP
.
Default Prorty (on Ingress)
Select
Crtcal
(default),
Low
,
Medum
, or
Hgh
. This is only used if the
QoS
Mode
field is set to
Force Prorty
.
Ingress Rate
Select the maximum rate allowed for
the port. For ports 1-5, the range is
8 kbps
to
Mbps
and for the wireless port the range is
8 kbps
to
Mbps
. The default is
No Lmt
.
Egress Rate
Select the maximum rate allowed for
the port. For ports 1-5, the range is
8 kbps
to
Mbps
and for the wireless port the range is
8 kbps
to
Mbps
. The default is
No Lmt
.
•
•
•
•
Switch > Spanning Tree
This screen allows you to configure the Spanning Tree
Protocol (STP) settings for the switch. STP can be used to
detect and disable network loops, and to provide backup
links between switches, bridges or routers. This allows the
switch to interact with other bridging devices (that is, an
STP-compliant switch, bridge or router) in your network
to ensure that only one route exists between any two
stations on the network, and provide backup links which
automatically take over when a primary link goes down.
STP is enabled by default.
Switch > Spanning Tree
STP
To enable STP, keep the default setting,
Enabled
. To
disable STP, select
Dsabled
.
Max Age
The maximum time in seconds that a device
can wait without receiving a configuration message
before attempting to reconfigure. The range is from
0,
to
seconds. The default value is
seconds.
Hello Tme
The interval in seconds at which the root
device transmits a configuration message. The range is
from
0,
to
seconds. The default value is
second.
Forward Delay
The maximum time in seconds that this
device will wait before changing states, such as from
discarding to learning to forwarding. The range is
to
5
seconds. The default is
seconds.
STP Table
Select the settings for the Spanning Tree table,
then click
Apply Port Settng
.
Prorty
The priority of this port. The smaller the
priority value, the higher the priority. If two ports form
a loop, the port with higher priority will change to
block state, thus breaking the loop.
Cost
The path cost to forward packets from this port.
It is usually inversely proportional to the port’s speed.
State
The Spanning Tree protocol: state:
Blockng
,
Learnng
, or
Forwardng
.
To apply the settings, click
Apply Port Settng
. To cancel,
click
Cancel
. To see the latest information, click
Refresh
.
•
•
•