Chapter 1
Product Overview
5
Wireless-G Broadband Router with 2 Phone Ports
Side Panel
Reset
There are two ways to reset the Router’s
factory defaults. Either press and hold the Reset
button for approximately ten seconds, or restore
the defaults from the
Administration > Factory
Defaults
screen of the Router’s web-based
utility. (The
Factory Defaults
screen allows
you to restore the Router and voice defaults
separately.)
NOTE:
Restoring the voice defaults
may require your login (the default
user name and password are
admin
). If
the defaults do not work, contact your
service provider for more information.
Stand
To place the Router in a vertical position,
rotate the stand 90 degrees.
Placement Positions
There are three ways to physically install the Router. The
first way is to place the Router horizontally on a surface.
The second way is to stand the Router vertically on a
surface. The third way is to mount the Router on a wall.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Place
the Router on a level surface near an electrical outlet.
Vertical Placement
The Router has a stand on the panel opposite to the
antenna. Rotate the stand 90 degrees, and place the
Router on a level surface near an electrical outlet.
Wall-Mounting Placement
The Router has four wall-mount slots on its back panel.
The distance between two adjacent slots is 60 mm
(2.36 inches).
Two screws are needed to mount the Router.
Suggested Mounting Hardware
2.5-3.0 mm
4-5 mm
1-1.5 mm
Note: Mounting hardware illustrations are not
†
true to scale.
NOTE:
Linksys is not responsible for damages
incurred by insecure wall-mounting hardware.
Follow these instructions:
Determine where you want to mount the Router. Make
1.
sure that the wall you use is smooth, flat, dry, and
sturdy. Also make sure the location is within reach of
an electrical outlet.
Drill two holes into the wall. Make sure the holes are
2.
60 mm (2.36 inches) apart.