Chapter 3
Advanced Configuration
33
Wireless-G Broadband Router with 2 Phone Ports
Elapsed Time
The amount of time elapsed since the last
reboot of the Router is displayed.
RTP Packets Sent
The number of RTP packets sent by the
Router is displayed.
RTP Bytes Sent
The number of RTP bytes sent by the
Router is displayed.
RTP Packets Recv
The number of RTP packets received
by the Router is displayed.
RTP Bytes Recv
The number of RTP bytes received by the
Router is displayed.
SIP Messages Sent
The number of SIP messages sent by
the Router is displayed.
SIP Bytes Sent
The number of SIP bytes sent by the
Router is displayed.
SIP Messages Recv
The number of SIP messages received
by the Router is displayed.
SIP Bytes Recv
The number of SIP bytes received by the
Router is displayed.
External IP
The external IP address used for NAT mapping
is displayed.
Line 1/2 Status
Lines 1 and 2 have the same status information available.
Hook State
The status of the Internet phone line’s
readiness is displayed. “On” indicates that it is ready for
use, while “Off” indicates that it is in use.
Registration State
The status of the line’s registration
with the service provider is displayed.
Last Registration At
The last date and time the line was
registered are displayed.
Next Registration In
The number of seconds until the
next registration is displayed.
Message Waiting
This indicates whether you have new
voicemail waiting.
Call Back Active
This indicates whether a call back
request is in progress.
Last Called Number
The last number called is displayed.
Last Caller Number
The number of the last caller is
displayed.
Mapped SIP Port
The port number of the NAT mapped
SIP port is displayed.
Calls 1 and 2 have the same status information available.
Call 1/2 State
The status of the call is displayed.
Call 1/2 Tone
The type of tone used by the call is
displayed.
Call 1/2 Encoder
The codec used for encoding is
displayed.
Call 1/2 Decoder
The codec used for decoding is
displayed.
Call 1/2 FAX
The status of the fax pass-through mode is
displayed.
Call 1/2 Type
The direction of the call is displayed.
Call 1/2 Remote Hold
This indicates whether the far end
has placed the call on hold.
Call 1/2 Callback
This indicates whether the call was
triggered by a call back request.
Call 1/2 Peer Name
The name of the internal phone is
displayed.
Call 1/2 Peer Phone
The phone number of the internal
phone is displayed.
Call 1/2 Duration
The duration of the call is displayed.
Call 1/2 Packets Sent
The number of packets sent is
displayed.
Call 1/2 Packets Recv
The number of packets received
is displayed.
Call 1/2 Bytes Sent
The number of bytes sent is
displayed.
Call 1/2 Bytes Recv
The number of bytes received is
displayed.
Call 1/2 Decode Latency
The number of milliseconds for
decoder latency is displayed.
Call 1/2 Jitter
The number of milliseconds for receiver
jitter is displayed.
Call 1/2 Round Trip Delay
The number of milliseconds
for delay is displayed.
Call 1/2 Packets Lost
The number of packets lost is
displayed.
Call 1/2 Packet Error
The number of invalid packets
received is displayed.
Call 1/2 Mapped RTP Port
The number of the NAT
mapped RTP port is displayed.
Call 1/2 Media Loopback
The Media Loopback feature
allows the service provider to test the quality of the
connection to the Router. The status of the feature is
displayed.