Linksys LAPAC1750PRO, Руководство пользователя

Страница: 42 / 121

40
Section 3: Configuring the Access Point
LAPAC1750PRO Access Point Software User Manual
TSPEC Video
ACM Limit Specify an upper limit on the amount of traffic the AP
attempts to transmit on the wireless medium using a
video admission control to gain access
TSPEC AP
Inactivity
Timeout
Specify the amount of time for an AP to detect a downlink
TS as idle before deleting it
TSPEC Station
Inactivity
Timeout Specify the amount of time for an AP to detect an uplink
TS as idle before deleting it
TSPEC Legacy
WMM Queue
Map Mode Select On to allow intermixing of legacy traffic on queues
operating as ACM
Use the Radio page to configure both Radio 1 and Radio 2 The settings on the
page apply only to the radio that you choose from the Radio drop-down list
After you configure settings for one of the radios, click Save and then select
and configure the other radio Be sure to click Save to apply the second set of
configuration settings for the other radio
NOTE:
Changing some settings might cause the AP to stop and restart
system processes If this happens, wireless clients will temporarily lose
connectivity We recommend that you change AP settings when WLAN
traffic is low
Rogue AP Detection
A Rogue AP is an access point that has been installed on a secure network
without explicit authorization from a system administrator Rogue access
points pose a security threat because anyone with access can mistakenly or
maliciously install a wireless AP that can potentially allow unauthorized parties
to access the network
The status page for Rogue AP Detection provides real-time statistics for all APs
detected by the LAPAC1750PRO Access Point in the vicinity of the network If
the AP listed as a rogue is actually a legitimate AP, you can add it to the Known
AP List Click Refresh to refresh the page
NOTE:
The detected Rogue AP List and Known AP List provide information The
LAPAC1750PRO Access Point does not have any control over the APs on
the lists and cannot apply any security policies to APs detected through
the RF scan
When AP detection is enabled, the radio will periodically switch from its
operating channel to scan other channels within the same band Neighbor AP
detection can be configured independently on each radio Click Save to refresh
the screen and display the most current information
NOTE:
Note: Rogue AP detection does not have any refresh mechanism and
the SSID are retained in the database once detected
To view information about other access points on the wireless network, click
the
Status > Rogue AP Detection tab