Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2011 – Linkcom – All rights reserved
9
4.1.1 Parameter programming
The initial state for programming is signaled by the programming confirmation tone. The unit will always
revert to this state after 5 seconds of inactivity, even if you have started to program a parameter.
When programming, there are two types of parameters. The majority are parameters with a
fixed
length.
The parameter is always saved immediately and is confirmed by Parameter Confirmation tone.
Parameters
with variable length
(parameters
1,2,32,33,34)
are saved after the inactivity period
expires (5 sec). However, a variable length parameter will be saved immediately when maximum
permitted number of digits is reached. For parameters 1 and 2 the maximum number of digits is 16, and
for parameters 32,33,34 it is 6.
If, during programming, you enter a number that is not allowable, then the unit immediately emits an
error tone.
The parameter will not be recorded or changed, and the unit will return to its initial
programming state and it will be possible to repeat the parameter setting or program another
parameter.
The unit stays inactive in programming mode for 34 seconds and will then automatically hang up. Every
time a DTMF tone is dialed, this period is reset. Alternatively, parameter 9 may also be selected to end
programming mode.
To program a parameter, enter the parameter number followed by the value you wish to set. The unit
will either respond with the Parameter Confirmation Tone, or one of the Error Tones.
•
Note 1.
if you wish to maintain the connection in programming mode (i.e. extend the 34 seconds
period) then it is necessary to occasionally press a key (e.g. *, # or 7). The unit will respond with
an error tone but the connection will be kept alive.
•
Note 2.
The # sign is not used in the values for parameters 32,33 and 34, and can be used to
immediately save the parameter.
•
Note 3.
If you hang up the phone during programming mode without press 9, the doorphone will
stay in programming mode during 30 seconds.
4.2 PC programming – Smile DoorPhone Config programm
To setup the unit from a PC you will require a special USB tool cable, available separately, and must first
install the USB driver and software. Refer to the CD for more details. The unit must also be connected to
the telephone line.
Procedure
:
•
Connect the
Smile Doorphone
to the phone line
•
Connect the unit to the PC with the special USB cable.
•
Run the software program. The unit will enter PC programming mode and emit the
Enter
programming tone
If connection is lost, it is necessary to disconnect the USB cable from unit
and connect it again. The unit will answer and, providing the program is running, it will confirm its
entry into programming mode again.
When the connection is correct, you can the firmware version of Smile DoorPhone (visible in bar).
