Linddana A/S
. Ølholm Bygade 70 . DK-7160 Tørring . T +45 75 80 52 00 . [email protected] . www.linddana.com
Brugsanvisning: TP 230 fra dato 02.11.2015 ©Copyright 2008
19
8.3.3
Sliver breakers
To improve the chip quality, the machine is equipped with type A sliver breakers at the factory
(see Figure 16).
When chipping hard seasoned wood, use type B sliver breaker (see Figure 17).
Type B sliver breaker is extra equipment.
Figure 16 Sliver breaker type A
Figure 17 Sliver breaker type B
What to do:
Stop the machine and turn off any power. Loosen the bolts holding the two sections of the rotor
housing together and open the rotor housing. Remove the four bolts and nuts holding the sliver
breaker in place (see Figure 18).
Figure 18 Replacing sliver breaker
When using sliver breaker type B, the knife gap must be
max. 8 mm
.
Once the sliver breakers have been removed or replaced, turn the rotor several revolutions to
ensure that it runs freely and there are no loose objects in the rotor housing. Now close the rotor
housing and tighten the bolts (see Figure 13).
