Lindab PENNY QN, Инструкция по установке, использованию и техническому обслуживанию

Страница: 9 / 60

9
SYNCHRONISATION OF A NUMBER OF UNITS
It is possible to synchronized up to 10 units contemporaneously, through wire (2 pole twisted pair type, max 30m length) so to have mode and inversion
time synchronized. When the unit is switched on for the fi rst time, the rotation direction of each unit (clockwise or anti-clockwise) is automatically
established. Other functionalities like speed, smart humidity control and boost, continue to be controlled independently on each single unit.
Wiring diagram as per fi g. 16B.
Maintenance can be carried out by the user as shown in fi gures 49-65.
MAINTENANCE
SPEED LED COLOUR ACOUSTIC SIGNAL
speed 1 single green led short, single
speed 3 double green led short, double
OFF* red led long
*press the button for 3 seconds.
ANOMALY POSSIBLE CAUSE SOLUTION
No icon shown on the controller LCD
display
Batteries are dead Change the batteries
Batteries are not present Check that batteries are in there
Batteries are wrongly positioned Position the batteries correctly
The icon fl ashes on the LCD
display
Low batteries Change the batteries
The unit does not execute the
command sent from the remote control
Lack of communication between the unit and the
remote controller
Go closer to the unit, pointing the controller to the
receiver on the left side of the unit
The unit does not operate
There is no voltage Check that the unit is correctly wired to the main supply
Ventilation unit does not couple correctly with the
support base
Check that the coupling is properly done
The unit operates at the maximum
speed
The Boost functionality is activated, on the display
the icon is shown
Wait until the boost timing ends (15 minutes)
or deactivate the boost function pressing the
button.
Unit speed suddenly increases The smart humidity control is activated
Wait until the smart humidity control phase ends (10
minutes) or deactivate the humidity control function
pressing the button for 5 seconds.
Fixed yellow led Dirty fi ters
Filters maintenance/replacement is needed: reset
fi lter operation has to be done
Fixed red led Antifrost protection is activated Wait until the antifrost phase ends (30 minutes)
Fixed blue led Boost is activated
Wait until the boost timing ends (15 minutes)
or deactivate the boost function pressing the
button.
Flashing blue led Smart humidity control is activated
Wait unitl the humidity control phase ends (10
minutes)
Fixed purple led
Ventilation unit does not couple correctly with the
support base
Check that the coupling is properly done
Acoustic signal to disable -
Press the button for 7 seconds: a green led
fl ashes.
TROUBLE SHOOTING
DISPOSAL AND RECYCLING
Information on disposal of units at the end of life.
This product complies with EU Directive 2002/96/EC.
The symbol of the crossed-out dustbin indicates that this product must be collected separately from other waste at the end of its life. The user
must, therefore, dispose of the product in question at suitable electronic and electro-technical waste disposal collection centres, or else send
the product back to the retailer when purchasing a new, equivalent type device.
Separate collection of decommissioned equipment for recycling, treatment and environmentally compatible disposal helps to prevent negative
effects on the environment and on health and promotes the recycling of the materials that make up the equipment.
Improper disposal of the product by the user may result in administrative sanctions as provided by law.
BACK UP BUTTON
In case the remote controller gets lost or the batteries are dead, speeds 1, 3 and OFF position can be selected from the on board touch button (C). The
air fl ow direction is always alternate and the operation mode (either comfort or ef fi ciency) is the last selected from the remote controller.