Lincoln Vrtex 360, Руководство оператора

Страница: 16 / 53

A-6
INSTALLATION
VRTEX
TM
360
A-6
TABLE & SWING ARM SET-UP:
1. Place counter weights on base.
2. Using the 3/16” (4.8 mm) allen wrench, remove the
two ¼” x 20 Allen-head screws from the base
assembly.
NOTE: The longer screw is in the top.
3. Insert red post into base assembly aligning the flat
on the pole with the hole.
NOTE: The post will only insert one way.
4. Using the 3/16” (4.8 mm) allen wrench, secure the
post into position by replacing and tightening the
screws.
6. Insert one of the collar pins into the post at the #6
location.
7. From the top, slide the table onto the post letting it
rest on the collar pin inserted in previous step.
8. Insert the second collar pin into the post at the #13
position.
9. Obtain the swing-arm from the rear of the
VRTEX TM
360 by removing the cable ties from the swing arm
and cable. Grey cable should remain connected to
the
VRTEX TM 360
(DO NOT CUT!).
Collar
Pins
5. Obtain the three post collar pins from the factory
packaging of the
VRTEX TM 360
.
Cable Tie
Swing Arm
Table
Post
T Pin
Grey Cable
(DO NOT CUT)
Table
Weights
Stand
Screws
Table
Weights
Stand
Screws