48
6.6 Mechanical connection options SMBM
For mechanical connection options, see Figure 31and 32
The supply (
1
) for the flow limiters of the SMBM series is
located by default on the connection module (
2
) mounted on the
right, with or without changeover valve (
3
). In the case of SMBM
with filter unit, the connection is located on the filter unit (
4
). In
the last module (on the left side), the so-called base module (
5
),
the pass-through inlet bore is closed by a plug screw with a
packing ring (R 1/2") (
6
).
A switching of the supply connection from right to left can be
implemented at the customer site with the SMBM-X flow
limiter, except when a filter unit is attached. This is not possible
with the SMBM-V flow limiter. The plug screw (
6
) is to be
tightened afterwards with a torque of 40 ±1 Nm.
The outlet boreholes of the modules are located on the front
side of the flow limiter, while on the rear side the boreholes are
each closed with one plug screw (R 3/8") (
7
) with packing ring. A
switching of sides for the outlet boreholes can be implemented
separately for each module. To this end, only the plug screw (
7
)
(with packing ring) is to be switched from the rear side to the
front side. The plug screw
7
is to be tightened afterwards with
a torque of 30 ± 1 Nm.
Fig. 31
Mechanical connection options SMBM-X
Содержание SKF SMBM-V EEX
Страница 49: ...49 Fig 32 Mechanical connection options SMBM V...
Страница 61: ...61 Fig 40 Replacement of an SMBM module...
Страница 62: ...62 Fig 41 Expansion of an existing assembly to include an SMBM module...
Страница 73: ...73...
