Lincoln IDEALARC DC-1000, Руководство оператора

Страница: 25 / 52

F-1
DIAGRAMS
F-1
IDEALARC® DC-1000
S17176
8-2-90F
CONNECTION OF DC-1000 TO LN-8
Connect the control cable ground lead to the frame terminal
marked near the power source terminal strip. The power
source must be properly grounded.
*If using an older control cable: Connect lead #75 to #75 on
terminal strip, connect lead #76 to #76 on terminal strip, connect
lead #77 to #77 on terminal strip.
N.A. Welding cables must be of proper capacity for the current
and duty cycle of immediate and future applications.
N.B. Extend lead 21 using #14 (2.5 mm 2 ) or larger insulated
wire physically suitable for the installation. An S16586-[ ]
remote voltage sensing work lead is available for this
purpose. Connect it directly to the work piece keeping it
electrically separate from the welding work lead circuit
and connection. For convenience, this extended #21 lead
should be taped to the welding work lead.
N.C. Tape up bolted connection.
N.D. Alternative 500 amp positive terminal connection provided
on DC-1000 models above code 9500 only.
Above diagram shows electrode connected positive. To change
polarity, turn power source off, reverse the electrode and work
leads at the power source and position the switch on power
source to proper polarity.
2 1 4
2
3 1 3 2 7 3 7 4 7 5 7 6 7 7
4
G
N
D
P O W E R S O U R C E
N E G A T I V E
P O S I T I V E
2 1
N . A .
E L E C T R O D E C A B L E T O
T O W O R K
}
T O L N - 8 I N P U T
C A B L E P L U G
C O N T R O L C A B L E
3 2
3 1
2
C
B
A } *
W I R E F E E D U N I T
N . D .
N . B . &
N . C .