Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
威
to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the
Programming
section, replace
Step 2 with the following:
Note:
If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink
威
button (note Step 2 in the
Programming
section) while you press and release —
every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
威
. The indicator light will
flash slowly and then rapidly after HomeLink
威
accepts the radio
frequency signal.
•
Proceed with Step 3 in the
Programming
section.
Operating the HomeLink
姞
Wireless Control System
To operate, simply press and release
the appropriate HomeLink
威
button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
2009 MKZ
(378)
Owners Guide, 2nd Printing
USA
(fus)
Driver Controls
70
