Lincoln Electric WAVE DESIGNER, Руководство оператора

Страница: 11 / 74

Section 2 2-3
SOFTWARE INSTALLATION
WAVE DESIGNER
SW1
SW2
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
ON
ON
CONTROL
BOX
CONTROL
BOARD
27850003
FRONT
PANEL
POWER
SOURCE
RS232
CABLE
COMPUTER
SYSTEM
27850004
FIGURE 2-2. CONTROL BOARD DIP SWITCH SETTING.
FIGURE2-3. INTERFACE CONNECTION.
PLEASE NOTE: Some IBM ThinkPads® by default have the serial port disabled and instead the port is used for infrared. The
following information describes the procedure to disable the infrared feature and enable the serial port. Follow the instructions
below to use COM1 to communicate with the PowerWave. More instructions at the end discuss how to use other ports, if
necessary.
The following information can also be found at the IBM website at http://www.pc.ibm.com/qtechinfo/DSHY-3P5QW4.html
How to enable the external serial port on your ThinkPad
SYMPTOM:
The ThinkPad is not communicating with the PowerWave serial device.
CONFIGURATION:
Any ThinkPad trying to utilize the external serial port using any applicable operating systems.
RESOLUTION:
By default, currently available ThinkPads come with the external serial port disabled and Infrared enabled on COM 1. To use
the serial port on COM 1 you must either disable infrared or change infrared so that it uses alternate resources. If you are not
using infrared for printing or file sharing it is recommended that it be disabled.
To disable infrared and enable the serial port on COM 1 do the following:
1. Double-click your ThinkPad Features or ThinkPad Configuration icon located in the ThinkPad folder on your desktop.
2. Locate the Infrared button located on the left-hand side of this configuration screen and click it once.
(Note: If you hold your mouse pointer over any of the icons in this configuration screen the button will be identified at the
bottom in the status window.)
3. Change Infrared from "Enable" to "Disable" and click "OK".
4. Locate the serial port icon and click it once.
5. Select serial port "enable" and insure that the COM PORT setting is "COM 1" and click "OK".
6. Shut down and restart the computer.
More Information:
There are many different combinations of port settings that are possible. The following table indicates the standard settings for
the four available COM Ports:
COM 1 03F8 4 COM 2 02F8 3
COM 3 03E8 4 COM 4 02E8 3
Please note that COM 1 and 3 share IRQ 4 and COM 2 and 4 share IRQ 3. You can not configure multiple devices to the
same IRQ.
If not successful, try to use COM3. Follow the instructions above while substituting COM1 with COM3. Configure Wave
Designer by changing the properties of the Wave Designer icon (right click mouse when pointing to the icon), add "-port com3"
to the command line.