Lincoln Electric WAVE DESIGNER, Руководство оператора

Страница: 45 / 74

8. “Go Figure” / Make the Waveform Synergic
Weld synergy is established by shaping the 2nd and all subsequent workpoints. Being synergic,
the waveform parameters automatically adjust to programmed data table values. The data table
values are unique for selected wire feed speeds. Thereby, the output of the power source
changes in response to changes in the wire feed speed, as controlled by the PowerWave’s WFS
encoder setting. The process of making the waveform synergic involves two procedures;
developing the 2nd workpoint and workpoints interpolation.
Developing the 2nd Workpoint
Develop the second workpoint in the same manner as the first.
Appendix A A-13
PULSE WAVE SHAPING PRINCIPLES
WAVE DESIGNER
WIRE FEED SPEEDS
WORKPOINT VARIABLE
WorkPoint Editor
WorkPoint Editor
1
0
2
3
4
5
6
7
8
9
10
11
80 700
80 700
110 700
150 700
205
300
400
600
inch / min meter / min
Go Figure
FIXED VALUE
INTERPOLATED/
EXTRAPOLATED VALUE
28750038
WP0, 1
WP2
WP3
WP5
WP6
WP7
WP8, 9, 10, 11
WP4
NOTE: In the workpoint window where workpoints 9 through 11 are not selected, they are
assigned the value of workpoint 8. This sets 700 as the upper limit on the operative
wire feed speeds.
Workpoints Interpolation
After shaping the second waveform, open the workpoint editor and click on the
button.
Wave Designer
interpolates the waveform parameters for each unchecked (not
selected) wire feed speed. These steps can be repeated multiple times to fine tune all the
workpoints. The set (fixed) wire feed speeds are those indicated (checked) in the workpoints
listing. Go Figure will interpolate/extrapolate between/from set workpoints.