www.liko.com
89
10.0
Periodic inspection
Instructions for the check points
3
Periodic inspection 3EN401002-01
1
(
a) Check for visible damage to the lift base surfaces, finish, etc.
- Check for scratches, dents, deformities or unusual surface wear.
2 Check castor wheels and forks
- Roll the lift unloaded along the
floor,
checking to
ensure
that all
castors
roll
and
turn
freely.
- Verify that the castor fasteners are tight. There should not be any play between the fork and the castor nut.
3 Check the castor brakes
Lock the brakes. Make sure the wheels do not turn and the castor housing does not swivel when the lift is pushed.
4 Inspect stop screw
- Verify that the K6S M8x60 screw is secured with a ny-loc nut inside the middle beam.
5 Inspect base opening and closing
Electrical Base:
-Inspect telescoping insert beam for scratches/gouges
-Inspect that all hardware is tight.
-Verify max. & min. dimensions. (For correct dimensions, see Technical data in Service manual)
6 Check base frame castor play & levelling
- Manually open and close legs at the front castors to measure wheel play. Base width wheel play should not exceed
35mm / 1.38 inch total.
7 Inspect Base attachment secure screws
-
In the upper holes on the mast: Verify that both locking screws are tight in base.
-
Note! Do not place any screws in the lower holes!
8 Inspect Handle
- Check for unusual scratches, dents or deformations.
- Verify that all four screws are tight in mast
9 Inspect the lift arm hardware and covers
- Inspect plastic lift arm cover for cracks. Verify that edges of cover are secured in groove of aluminium arm.
- Inspect sling size label is positioned on the liftarm.
10 Inspect Liftstrap
-
Using the handcontrol, lower the strap to its maximum extension. Inspect the belt for frayed edges, heavy wrinkles
or wear through areas.
- Verify Q-link is secure on strap. Slide plastic cover off the Q-link and visually inspect that the lift strap safety pin is
seated securly in the middle recess of the Q-link.
11 Inspect the slingbar bearings and safety latches
- Inspect visually that the slingar is free from any scratches, sharp edges or deformities.
- Make sure that both safety latches are mounted and fall back against the body of the slingbar.
- Verify that the slingbar adapter are secured.
12 Check battery & electrical cable installations
- Verify battery charge (recharge battery or test with Prod. No. 2101100).
- Inspect that all cords are in the proper receptacles of the control box
hand control (large DIN receptacle), mast actuator (middle receptacle, port #1), base motor (end receptacle, port #2),
extension cord (in front two pin connector) connected to the charging cable.
- Verify that all cables are properly inserted. Reinsert if uncertain.
Golvo 7000/7007 ES, Classic
