www.liko.com
Assembly Instruction
62
5. 295.1
Tools required:
13 mm
4. Use the pin to lock the axle where
the strap was mounted.
5. Push the emergency lowering
handle down and pull the strap
away.
3. Remove the pin. Do not let go
of the springloaded wheel, since the
tension will release.
6. Pullthe rest of the strap out and
remove the plastic housing.
7. Mount the new strap through the
plastic housing with the red mark
towards the plastic housing and
then as shown above.
8. Do not let go of the springloa-
ded wheel, since the tension will
release. Mount the strap through the
slot in the axle and the same way
back.
Note!
The axle has two diffe-
rent sides. Place the pin as shown
to lock the strap.
10. Roll the strap up until the red
mark reaches the plastic housing.
9. Push the plastic housing on to the
strap joint.
2. Hold the springloaded wheel and
release the strap by removing the
pin.
1.
Pull the strap all the way out.
Body/Handle set for
Emerg. Low. Device G7/G77
Prod.no: 20090068
Doc. no:
2005-06-20
