12
www.hillrom.com
7EN140108 Rev. 4 • 2020
Disassembly
1. Begin by removing the sling bar or other accessory that is fitted to the lift.
2. Remove the armrest holder as described below:
A. Do not remove, just loosen the two M8 screws in the
armrest holder on either side of the lift mast.
B. Remove the armrest holder using two screwdrivers.
Place screwdrivers inside on top of handlebar and pull up
simultaneously as illustrated.
3. Loosen the cables from the control box, see assembly, Remove the mast as described below:
A. Unscrew both the safety screws in the upper holes on the
mast.
B. Then screw the safety screws into the lower holes on the
lift mast. This releases the mast from the base, and it can
now be removed.
When the mast has been detached from the base, it must be supported to prevent it from falling
.
Operation
Handcontrol operation and indicators
Operate the lift using the push buttons on the handcontrol. For raising and
lowering: Directional arrows show the direction of movement (up/down)
The lifting and base movement stops as soon as the push button is released.
Indicator: 1 - 4
1 - Overload (Kg/Ibs) light "flashes yellow", too much load is applied to the lift.
2 - Green light, battery power (100 - 50 %), Ok!
- will constantly light up green when charger is connected to mains.
3 - Yellow light, battery power (50 - 25 %), battery needs charging
4 - Yellow light, battery power (Less than 25 %), battery needs charging.
A buzzer will sound when pressing a push button.
Note! If the buzzer sound starts during an ongoing lift complete the lift
and charge the lift afterwards!
4 - Light "flashes yellow" and a buzzer will sound when pressing a push button.
Charge the lift immediately! The remaining battery power can only make
the lift arm go down.
Note!
Please see chapter "Charging the Battery" for more information.
Cable
Push buttons:
Lift arm:
Up
/ Down
Lift arm (low speed):
Up
/ Down
Push buttons:
Base width:
Out
In
kg/lbs
Indicator: 1 - 4
kg/lbs
2
3
4
1
