13
www.hillrom.com
7EN140108 Rev. 4 • 2020
Control Box operation and information
1. Emergency Stop button
- Activate: Push the red button
- Reset: Turn the red button clockwise.
2. UP (Arrow), Electrical emergency lifting.
3. DOWN (Arrow), Electrical emergency lowering.
Operation of the push buttons 2 and 3 are done by pressing
with a narrow object into the circle mark above each (Arrow).
The Actuator movement stops as soon as the push button is released.
4. "ON" - lights up green when the charger is connected to mains.*
5. "CHARGE" - lights up yellow constantly during charging and will turn off when
charging is completed.
6. Display Pop-up information:
Battery power (100 - 50 %) Ok!
Battery power (50 - 25 %) Battery needs charging.
Battery power (Less than 25 %) battery needs charging.
A buzzer will sound when pressing a push button.
Note! If the buzzer sound starts during an ongoing lift complete the lift
and charge the lift afterwards!
Charge the lift immediately! A buzzer will sound when pressing a
push button. The remaining battery power can only make the lift arm go down.
The lift is connected to the mains.
Short circuit warning!
check cables and connections.
Warning is shown until repaired!
Overload!
Too much load is applied to the lift.
Service needed; contact Hill-Rom.
SHORT CIRCUIT
CHECK CONNECTION
!
kg/Ibs.
service
6
4
3
5
2
ON CHARGE
BATTERY
1
Total number of lift cycles with load
Work done by actuator; Amp. x Sec.
Number of overload indications
Days since last service/Days between services.
xxx
xx/xxx
xxxxxx
xxxxx
A x S
kg/Ibs.
service
6. Information display:
Activate information display by a "quick press" at a UP,
push button.
Li-ION battery - specific information
Sleep mode!
the sleep mode will be activated in a Li-ION battery if not in use or charged in one week or more. The sleep
mode switches off the battery and it´s electronics to save power. The battery will stay in sleep mode until the battery is set
back to operation mode again.
How to set the Li-ION battery back in operation mode;
Charge the battery, when the "CHARGE" indicator,
5
is lit the
battery has been set back in operation mode and ready for use. Note! We recommend to charge the battery until charging
is completed, see "Charging the Battery" for more information and instructions.
Delay!
a delay to indicators for current battery power at the control box and hand control occurs if the emergency stop
function is activated and restored, see 1 above.
