Lika SMAX-AI1-PRG-L2, Руководство пользователя

Страница: 16 / 84

SMAX MODBUS®
compressed air, etc.) are in place in order to prevent the sensor and the
magnetic scale from jamming.
Make sure the mechanical installation meets the system's requirements
concerning distance, planarity and parallelism between the sensor and the scale
indicated in Figure 2 all along the whole measuring length.
MTAX magnetic scale can be provided with a cover strip to protect its magnetic
surface (see the order code).
Figure 1 shows how the sensor and the scale must be installed; the arrow
indicates the
standard counting direction
(increasing count when the sensor
moves in the direction indicated by the arrow; further information can be found
in the “Code sequence” section on page 64).
WARNING
The system cannot operate if mounted otherwise than illustrated in Figure 1.
3.3 Mounting the sensor
Figure 1
Make sure the mechanical installation complies with the system requirements
concerning distance, planarity and parallelism between the sensor and the scale.
Avoid contact between the parts. Sensor is fixed by means of
two M4 25 mm
min. long cylinder head screws
inserted in the provided holes. Recommended
minimum bend radius of the cable: R

25 mm . Install the sensor and the
magnetic scale as shown in the Figure. The system does not operate if mounted
MAN SMAX MB E 1.2 Mechanical installation 16 of 84