Lika SMAX-AI1-PRG-L2, Руководство пользователя

Страница: 64 / 84

SMAX MODBUS®
Byte 0
Scaling function
bit 0 This is meant to enable / disable the scaling parameter
Resolution [0000 hex]
. When the scaling function is
disabled (bit 0 = 0), the encoder uses its own default
resolution; otherwise, when the scaling function is enabled
(bit 0 = 1), the encoder uses the resolution set next to the
Resolution [0000 hex]
register. Complete information at
the
Resolution [0000 hex]
register on page 59.
The default features of the SMAX linear encoder are:

Default resolution
= 0.1 mm

MTAX-680 max. measuring length = 600 mm

Max. number of information
= 6,000 (13 bits)
To know whether the
Scaling function
is currently enabled,
you can read the Scaling bit 0 of the Status word [0006
hex] , see on page 72.
Code sequence
bit 1 This is intended to set if the count is increasing (count up
information) either when the sensor moves in the direction
indicated by the arrow in Figure 1 or when the sensor
moves in reverse of the standard direction, i.e. in the
opposite direction to the one shown by the arrow in Figure
1. Setting 0 (bit 1 = 0) causes the encoder counting to
increment when the sensor moves as indicated by the arrow
in Figure 1; setting 1 (bit 1 = 1) causes the encoder
counting to increment when the sensor moves in reverse of
the standard direction, i.e. in the opposite direction to the
one shown by the arrow in Figure 1.
To know whether the
Code sequence
is currently enabled,
you can read the
Counting direction
bit 1 of the
Status
word [0006 hex]
, see on page 72.
MAN SMAX MB E 1.2 Programming parameters 64 of 84