Lightning SA MultiCom, Руководство пользователя

Страница: 106 / 172

Chapter 5 Troubleshooting
106 MultiCom Firewall User’s Manual
NOTE - Resetting the default configuration this way does not erase
your user accounts. To load the default configuration with the default
"multicom" user account you will need to follow the instructions for
For firmware 3.0-3.4.1 below.
For firmware 3.5+
1. Leave the MultiCom Firewall powered on
2. Hold down the config button in the back, using a ballpoint pen if available,
for 6 or more seconds will load the default configuration. (holding the config
button down for 3 seconds will load the boot config.)
For firmware 3.0-3.4.1
1. Power off the MultiCom Firewall.
2. While holding down the config button in the back (using a ballpoint pen if
available), turn on the MultiCom Firewall.
3. Wait for the firewall to finish booting up; this is when the LAN and WAN
light remain either a steady green or red and the rest of the LEDs have
stopped blinking.
The factory default configuration is then loaded up into the current memory
location of the MultiCom Firewall. Configurations that were stored in the
firewall prior to the reset are still saved in the memory of the firewall.
CAUTION - This configuration is temporary and unless you save it to
the Boot Memory location on the firewall, your original configuration
will return after a reboot.
To completely reset the firewall you will need to save this default configuration to
the Boot Config memory location so that every time the firewall reboots it will
load the default configuration.
This may be useful if you have configured your firewall in such a way that it is
inaccessible (accidentally typing in the wrong IP address or if you have moved
the firewall to a different network).