Lighthouse Remote 2014P, Руководство по эксплуатации, Страница: 34 / 80

Lighthouse REMOTE 2014P, 3014P, 5014P Operating Manual
3-14 248083408-1 Rev 1
3. Apply power to the REMOTE. Apply power to the PC if it is not
already running. Observe the LEDs on the hub/switch RJ45
connector - blinking indicates network activity. Observe the
network LEDs on the instrument’s RJ45 receptacle - they should
blink indicating activity. Proceed to next section.
Program the
Interface
Windows Telnet Programming:
1. Start Windows.
2. On the Taskbar, click on
Start
.
WARNING:
Perform
only the steps or
commands as provided
in this guide. Failure to
heed this warning can
result in damage to
equipment, personal
injury or data loss and
may void the equipment
warranties.
3. Select
Run
.
Figure 3-7 RUN Screen
4. In the Run window, type CMD and click OK.
Note:
Typing commands
in the command console
requires a space between
the instruction and the
command variables. For
example, ’arp’ is followed
by a space, then ’-d’ and
another space, then the *.
Figure 3-8 Starting the Command Console