Lighthouse Remote 2014P, Руководство по эксплуатации

Страница: 29 / 80

Unpacking, Inspecting and Installing
248083408-1 Rev 1 3-9
Using the USB Port to connect to a PC
Note:
Make sure the
USB driver has been
installed on the PC before
connecting and applying
power to the instrument.
To connect the instrument to a computer using the USB port, make sure
that the driver has been installed first. Connecting the instrument to the
PC and applying power before the driver has been installed will be
problematic. Refer to the following:
1. Remove power from the instrument.
2. Connect Side B of a standard “A to B” USB cable (See Figure 3-5)
to the instrument (only Side B will fit).
Figure 3-5 “A to B” USB Cable
3. Connect Side A to any available USB port on the PC.
4. Apply power to the instrument.
5. Windows will recognize that a new hardware device has been
attached and will finalize the installation as needed. This is a
routine “registering” of components that should take only a
moment. An additional COM port will be added to the PC.