Lighthouse Remote 2014P, Руководство по эксплуатации

Страница: 33 / 80

Unpacking, Inspecting and Installing
248083408-1 Rev 1 3-13
Configure
Device
Ethernet Port Configuration
This section is organized based on the cable used to perform the
REMOTE programming.
Straight-through Cat5 requires a hub or switch and two straight-through
Cat5 cables. Cross-over Cat5 connects the PC directly to the REMOTE
P with no hub. Each will be explained separately. If troubleshooting is
required, the cross-over cable technique is easier to use in the field
because it requires fewer devices.
It cannot be stressed enough, however, that the instrument and PC be
configured using the same IP scheme (IP range, Default Gateway and
Netmask).
For troubleshooting outside of the LAN, it is suggested that the PC’s IP
address be used as the Default Gateway for both the PC and the
REMOTE P.
Frequently, it is necessary to change the instrument’s Ethernet
parameters to allow for easier troubleshooting. When this is needed,
make sure the instrument is reprogrammed to its previous network
settings before reattaching to the LAN. Contact Lighthouse Technical
Support or the network administrator for additional information.
Straight-through Cat5 Setup:
Note:
Screens shown
are examples only. Data
displayed and command
responses may differ.
This section requires the PC, two straight-through Cat5 cables and the
hub or switch.
1. Connect one end of a straight-through Cat5 cable to the
REMOTE’s Ethernet Port.
2. The other end of the Cat5 cable should plug into one port on the
hub or switch.
3. Attach another straight-through cable to the PC’s RJ45 receptacle
and an open port on the hub or switch.
4. Proceed to “Windows Telnet Programming:” on page 3-14.
Cross-over Cat5 Setup:
1. Attach one end of the cross-over cable to the RJ45 receptacle on
the PC.
2. Attach the other end of the cable to the REMOTE P Ethernet Port.