MASTER/SLAVE MODE
CONNECTIONS
To connect multiple units in Master/Slave mode you need to connect a 3 pin
DMX lead (Refer to Fig 7) from the DMX output socket of the master to the
DMX input socket of the slave, then from the DMX output socket of the first
slave to the DMX input socket of second slave and so on and so forth. (Refer
to Fig 10.)
SETTINGS
You then need to set the unit to Master/Slave mode by flowing these steps
1. Set the first unit to sound or auto mode as per the Stand-Alone
instructions
2. Set the rest of the units to DMX address 1 (refer to DMX mode)
DMX MODE
NOTE
:
To determine the address required you should refer to your DMX controller’s
manual
Do not forget to use a DMX terminator at the final output in the chain
Do not forget to turn off the ‘Blackout’ on your controller
CONNECTION
To connect the lighting effect in DMX mode you need to use a 3 pin DMX lead
(Refer to Fig 7) from the DMX output socket of the controller to the DMX input
socket of the first unit, then from the DMX output socket of the first unit to the
DMX input socket of second unit and so on and so forth. (Refer to Fig 10)
SETTINGS
You then need to set each unit’s DIP switches to the addresses required
(REFER to DIP switches section)
6/8
