12
4. Handlebar and Computer Installation
Insert the Hand Pulse Sensor Wires (6) into the hole on the Handlebar Post (14) then pull
them out from the top end of the Handlebar Post (14).
Place the Handlebar (4) through clamp on the Handlebar Post (14) with hand pulse sensors
facing the seat.
Hold the Handlebar (4) in desired position and fasten Clamp Cover (12), Ø12x1.5x20 Spacer
(10), and M8x55 Handlebar T-Knob (9) onto clamp. Tighten the M8x55 Handlebar T-Knob
(9) after adjustment.
NOTE:
Handlebar T-Knob should be tightly secured before using.
Remove four M5x12 Cross Recessed Pan Head Bolts (77) from the back of the
Computer (1). Remove bolts with the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Hand Pulse Sensor Wires (6) and Computer Extension Wire II (3) to the wires
that come from the Computer (1). Tuck wires into the Handlebar Post (14). Attach the
Computer (1) onto the top end of the Handlebar Post (14) with four M5x12 Cross Recessed
Pan Head Bolts (77) that were removed. Tighten bolts with the Multi Hex Tool with Phillips
Screwdriver provided.
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
14
77
10
9
1
12
4
3
6
