49
6.
Assemble the MATING BRACKET (q) to the back of the
ATTACHABLE TV (bb) with four SCREWS (r) and four steel
WASHERS (s).
7.
Assemble the ATTACHABLE TV (bb) to the TV MOUNTING
BRACKET. Insert one HEX BOLT (t) and WASHER (u) through
both parts that make up the hinged bracket. Partially
tighten both brackets with one LOCKNUT (v). Adjust the TV
position so that the TV face is perpendicular to the fl oor. Insert
two SCREWS (w) to lock the bracket position. Fasten the
hinged bracket securely.
8.
Insert one end of the AUDIO / VIDEO / I-R REMOTE
CONTROL CABLE ASSEMBLY into the CONSOLE
CONNECTOR.
Attach the FERRITE to the main CONSOLE CONNECTOR
(See “g” on previous page)
. Attach the CABLE TIE below
the FERRITE to prevent the FERRITE from sliding down
the cable after the FERRITE is placed into the MAIN
CONSOLE SUPPORT CABLE ACCESS HOLE.
9.
Reattach the console to the console support bracket with the four
previously removed screws in Step 2.
Connect the COAXIAL CABLE, POWER CORD, and AUDIO / VIDEO / I-R REMOTE CONTROL CABLE ASSEMBLY
to the rear of the ATTACHABLE TV. See the
Media Connections
pages in this manual for detailed information.
10. Re-insert the previously removed square END CAP (a) into the top of the TV MOUNTING BRACKET.
11.
Secure the POWER ADAPTER (x) to the FRONT STABILIZER (y) using two CABLE TIES (z) as shown. Be sure the
CABLE TIES are pulled tight and trim the excess CABLE TIES. Connect the screw-type connector of the POWER
SUPPLY CORD (aa) to the underside receptacle. Bundle excess power cord and store under the unit.
Connect the COAXIAL CABLE (f) to the broadcast supply cable in similar fashion.
12. Connect the POWER SUPPLY CORD to the POWER ADAPTER (x).
13. Continue with the remainder of assembly as instructed in the Assembly Instructions. Plug the POWER SUPPLY
CORD into an electrical outlet upon completion.
f
aa
x
z
y
s
r
t
w
u
v
q
bb
