11
I
NSTALLATION
Models:
95T Elevation Inspire & 95T Elevation Discover SI
Tools Required:
Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit:
(1) Main Bracket Cap, (1) Grommet
1.
Turn off the treadmill and unplug it from the power outlet.
For 95T Elevation Inspire Units Only:
1a.
Remove the six screws securing the motor cover. Remove the motor
cover and set it and the screws aside.
1b.
Remove the protective liner from one of the provided fastener strips.
Attach the fastener strip to the bottom of the POWER BLOCK (1).
Interlock the remaining fastener strip to the installed fastener strip.
Remove the remaining protective liner from fastener strip and secure
the power block to the frame as shown.
1c.
Plug the POWER CORDS (2) leading from the motor compartment
and left upright into their respective ends of the POWER BLOCK (1).
Feed excess cable into the left upright.
1d.
Re-install the motor cover using the six previously removed screws.
2.
Attach the LOWER MOUNTING BRACKET (3) to the MAIN BRACKET (4) as shown using four SCREWS (5) and
WASHERS (6) each. Tighten the screws securely (8-10 ft. lbs.).
3.
Slide the NEW BRACKET COVER (7) over the top end of the MAIN BRACKET (4) and down to meet the LOWER
MOUNTING BRACKET (3) as shown.
4.
Attach the TV BRACKET
(with bent tab)
(8) to the MAIN BRACKET (4) as shown using four SCREWS (5) and
WASHERS (6). Tighten the screws securely (8-10 ft. lbs.).
2
2
1
7
8
6
5
5
6
3
4
