LIFAN Power USA ENERGY STORM ESI2500iER-EFI-CA, Инструкция по эксплуатации и руководство пользователя

Страница: 34 / 107

L I F A N P O W E R U S A Page 33
Maintenance (continued)
OIL CHANGE PROCEDURES:
Periodic Maintenance of your engine oil should be performed after each 40 hours of use of you Power Equipment
Product. Check your engine oil level prior to each use.
1. Start your engine and let it warm up to get the oil warm and thinner. Turn the ignition switch to the “STOP”
position.
2. Remove the Right Access Cover.
3. Remove the oil cap/dipstick by turning counter clockwise. Remove the oil drain plug located below the oil
cap/dipstick utilizing the appropriate tools.
USE CAUTION: THE OIL MAY BE HOT.
4. Drain the engine oil using the provided Oil Drain Tube into an approved receptacle and discard in
accordance with all Federal and State Regulations. Never dump the used engine oil on the ground or into
drains, only discard in an approved manner. Check with your local authorities to determine the regulations in
your area.
WARNING! AVOID SPLASHING OF HOT OIL; IT CAN BURN YOU AND CAUSE SEVERE INJURY.
5. After oil is completely drained, replace oil drain plug and tighten with appropriate tools. Replace oil with the
proper oil for your product. Refer to the Pre--­Operating Instruction: Generator Setup section for exact fill
requirements.Always use your dipstick to check the oil level and only fill to the full mark on the dipstick.
Never overfill the engine as this can cause damage to the unit and void warranty.
6. Replace the dipstick/oil cap on the engine.
7. Replace Right Access Cover.
8. Shake generator to ensure the float in the Oil Alert System is free.
PROPER MAINTENANCE OF THE UNIT WILL INCREASE THE LIFE OF YOUR PRODUCT. THE OIL MUST BE CHANGED ON A
REGULAR BASIS FOR PROPER OPERATION, AND RELIABILITY AND TO ALSO MAINTAIN THE WARRANTY ON THIS
PRODUCT.