DL-SC41UP-BXTX Installation Guide
16
The
Display Setting
menu allows you to configure RS232 serial strings to be transmitted to a connected display
to the DL-SC41UP-BXTX RS232 port. An RS232 / serial connection must be made from either device to a display
for this option to work.
Refer to the projector or displays owners manual to obtain the RS232 / serial strings for control. You will want to
locate the ON, OFF, and INPUT string for the device, what the default baud rating is for the serial connection on
the display, what pins should be terminated for TX,RX and how the commands must be terminated i.e. carriage
return, line feed etc. Be sure the TX, RX pins are appropriately connected from the display to the switcher. See
page 9 for making a serial connection.
RS232 Display Control Settings
Enter baud rate of the display under
BAUD RATE
Enter the string terminator under
COMMAND ENDING
• NULL
- None
• CR
- Carriage Return
• LF
- Line Feed
• CR + LF
- Carriage Line Feed
Enter the display ON string in the
DISPLAY ON
field
Enter the desired time delay in seconds in the
INPUT DELAY
field for the input command. The input command
will be transmitted to the display after the input command has been generated.
Enter the desired display input string in the
DISPLAY INPUT SELECT
field
Enter the display OFF string in the
DISPLAY OFF
field, check the X2 box if the command must be repeated 2 times
then enter the display off delay in seconds in the
DISPLAY OFF X2
DELAY field.
Click
SAVE
to save settings
NOTE:
The DISPLAY ON and OFF strings saved in this menu will be triggered manually with the DL-SC41UP-BXTX
front panel
DISPLAY POWER
button
