LGC wireless InterReach Fusion SingleStar, Инструкция по установке и эксплуатации, Страница: 128 / 154

Troubleshooting
8-4 InterReach Fusion SS Installation, Operation, and Reference Manual
CONFIDENTIAL
D-620605-0-20 Rev A
Component Troubleshooting
If a device has faults, select it, right click on it to get the pull down menu, then exe-
cute
U
NIT
C
OMMANDS
/ G
ET
F
AULTS AND
W
ARNINGS
.
8.3.1.1 Troubleshooting Recommendations
Some actions that you can take, depending on the device fault or warning include, are
as follows:
a.
Issue a C
LEAR
A
LL
D
ISCONNECTS
at the Fusion SingleStar Hub.
b.
Power cycle the Fusion SingleStar Hub.
c.
RAU hardware faults. Try swapping the CATV at the Fusion SingleStar Hub
with a good CATV cable.
d.
Try isolating the system components:
– Check to see if the whole system is effected or a portion of the system.
– If the whole system is effected, disconnect the DAS system from the RF
source and see if the RF source is working.
– Continue to isolate by disabling portions of the system. Use the
U
NIT
C
OM
-
MANDS
/S
ET
O
UT
-
OF
-S
ERVICE
and
S
ET
I
N
-S
ERVICE
.
8.3.1.2 Fault Indications
Once all of the units are powered on and the cable connections are made, the faults
from each unit can be requested using AdminBrowser. Start with the Fusion Single-
Star Hub and work downstream.
Resolve all faults first and then check the warnings. Take appropriate action to
resolve the faults, as indicated in the following tables. In cases where there is more
than one possible cause, they are listed from the “most likely” to the “least likely”
cause. Actions are listed in the order that they should be performed; not all actions
may need to be done.
NOTE:
If you have a red
STATUS
LED without a fault message, it probably
indicates that the unit is locked out.