■
Bundle the piping and drain hose together by wrapping
them with cloth tape over the range within which they fit
into the rear piping housing section.
8. Reroute the pipings and the drain hose across the
back of the chassis.
9. Set the pipings and the drain hose to the back of
the chassis with the tubing holder.
■
Hook the edge of tubing holder to tap on chassis and
push the bottom of tubing holder to be engaged at the
bottom of chassis.
10. Indoor unit installation
■
Remove the spacer.
■
Ensure that the hooks are properly seated on the instal-
lation plate by moving it left and right.
Press the lower left and right sides of the unit against the
installation plate until the hooks engage into their
slots(clicking sound).
3) Connection of the pipes-Outdoor
1. Align the center of the pipings and sufficiently
tighten the flare nut by hand
2. Finally, tighten the flare nut with torque wrench
until the wrench clicks.
■
When tightening the flare nut with torque wrench,
ensure the direction for tightening follows the arrow on
the wrench.
- 30 -
Drain hose
Vinyl tape
(narrow)
Pipe
Wrap with
vinyl tape(wide)
Outdoor unit
Outdoor unit
Liquid side piping
(Smaller diameter)
Gas side
piping
(Bigger
diameter)
Torque wrench
Torque wrench
Piping for
passage through
piping hole
Tubing holder
Hook
Push
2
1
Drain hose
Connecting
cable
Pipe Size[Torque]
GAS
LIQUID
9K
1/2"[5.5kg.m]
1/4"[1.8kg.m]
12K
1/2"[5.5kg.m]
1/4"[1.8kg.m]
18K
5/8"[6.6kg.m]
1/4"[1.8kg.m]
24K
5/8"[6.6kg.m]
3/8"[4.2kg.m]
Capacity
(Btu/h)
