3) How to fix installation plate
The wall you select should be strong and solid enough to
prevent vibration
1. Mount the installation plate on the wall with four
type A screws. If mounting the unit on a concrete
wall, use anchor bolts.
■
Mount the installation plate horizontally by aligning the
centerline using a level.
2. Measure the wall and mark the centerline. It is also
important to use caution concerning the location of
the installation plate-routing of the wiring to power
outlets is through the walls typically. Drilling the
hole through the wall for piping connections must
be done safely.
■
For right rear piping and left rear piping, draw a line in the
direction of the arrow marked "A". The meeting point of the
two lines is the center of the hole.
• The position of the center of the hole.
4) Drill a hole in the wall
■
Drill the piping hole with a ø70mm (0.76") hole core drill.
Drill the piping hole at either the right or the left with the
hole slightly slanted to the outdoor side.
- 25 -
Hole center
Right rear piping
Left rear piping
ø70mm
(2.76")
ø70mm
(2.76")
50mm
(1.97")
20mm
(0.79")
20mm
(0.79")
80mm(3.15")
A,B
A,B,C
C
D
D
A,B,D
C
A
B,D
C
ø70mm(2.76")
Left rear piping
Right rear piping
Hole Center
Installation plate
9K Btu
12K Btu
A,B
A,B,C
C
D
D
A,B,D
C
A
B,D
C
ø70mm(2.76")
Left rear piping
Right rear piping
Hole Center
Installation plate
18, 24K Btu
5-7mm
(0.2~0.3")
Indoor
WALL
Outdoor
Installation Plate
Marking-off line
Thread
Weight
Type "A" screw
A
A
A
A
Left holecore position
Right holecore position
