– 27 –
Door Assemblies
The doors can be separated into two assemblies:
(1) Outer assembly which consists of handle, vent
trim, outer glass, and frame; (2) Inner assembly
which consists of inner panel, gasket, glass
panels, and insulation. The assemblies are held
together by one T-20 Torx screw on each top
corner of the inner panel, and four ¼-in. hex-head
screws across the bottom.
Self-Clean Door Gasket -
The door gasket
is held in place between the outer and inner
sections of the inner door panel.
To remove the door assemblies:
Remove the oven door (See
Oven Door
.)
Place the oven door inside up on a protected
flat surface.
Remove two T-20 Torx screws and washers
from the top corners of the inner panel, the
4 center 1/4-in. hex-head
screws from the
bottom of the door, and remove the inner
assembly.
Place the inner assembly on a flat protected
surface with the inside up.
Remove the four ¼-in. hex-head screws, the
inner door panel, and the insulation.
1.
2.
3.
4.
5.
Remove the four ¼-in. hex-head screws from
the outer frame and carefully lift off the outer
frame.
6.
Note:
When replacing the gasket, be sure the
gasket bead is positioned uniformly between the
outer and the inner sections of the inner door
panel.
