GDK-100
DIGITAL KEY TELEPHONE SYSTEM
138
SECTION 5. CUSTOMER DATABASE PROGRAMMING
5.1 INTRODUCTION
The GDK Key Telephone System can be programmed to meet each customer's individual need. All
programming is done at station 100 (station port # 00) using KD-36D digital key telephone. (You cannot
program with Large LCD keyset.)
Upon entering the program mode, the key telephone at station 100 cannot operate as a normal
telephone but as a programming instrument with all of the buttons redefined. The keys of the dial pad are
used to enter the various data fields and to enter numerical information. The 24 buttons located at the top
of the phone (Flexible Buttons) are used to indicate the specific data field and to enter information.
Sometimes the
[SPEED]
button and ‘*’ of the dial pad is used to delete the data or to indicate end of data
input.
See TABLE 5.5.1 - 5.5.9 for default data. If this pre-programming suits the customer, additional admin
program is not necessary. To change admin data, the user enters the admin. programming mode and
select program code. During admin programming other keysets operate normally.
When Admin programming, LCD and LEDs indicate the current programmed data and status. If
the programmer enters correct data, then LCD and LEDs show the entered data and the data is
stored in the temporary buffer area. Real system databases is not changed and has no effect on
telephone operation unless permanent-updating procedure is executed. Pressing
[HOLD/SAVE]
button, all data in the temporary buffer (same as LCD and LEDs show their status) is saved into
permanent memory. Tones are provided to let the programmer know data entry is correct
(confirmation tone) or not (error tone).
5.2 TO ENTER THE PROGRAMMING MODE
1. Lift handset or press the
[MON]
button on the admin station, and hear ICM dial tone
(optional).
2. Press
the
[TRANS/PGM]
button and dial
#
(Confirmation tone is heard).
3. Enter Admin password if the password has been set. This places the station into the admin
programming mode (confirmation tone heard).
Each program is accessed by pressing the
[TRANS/PGM]
button and dialing the two-digit
program number. If an error is made while entering data, the [
▲
▲
▲
▲
] or the
[TRANS/PGM]
button can
go the previous status. When the
[TRANS/PGM]
button is pressed, the LCD will display;
ENTER PROGRAM CODE
Содержание GDK-100
Страница 2: ...GDK 100 DIGITAL KEY TELEPHONE SYSTEM ii Blank sheet ...
Страница 52: ...GDK 100 DIGITAL KEY TELEPHONE SYSTEM 43 LKD 2NS LKD 8DS LKD 30DS LKD 30LD Figure 2 4 3 LKD Digital Keysets ...
Страница 53: ...GDK 100 DIGITAL KEY TELEPHONE SYSTEM 44 GSX 8BTN Figure 2 4 4 GSX Electronic Keysets GSX 33 EXE ...
