LG AK3GEUS, Справочник данных

Страница: 64 / 79

64 Accessories
Mechanical accessories 6RWU0-06A
PTAC
2.2 Outer Grille
Outdoor Grilles are attached to the Wall Sleeve and exposed to the exterior Wall. These Grilles comes in industry standard
size of 42" x 16". These Grilles are of two types :
(a) Stamped Aluminum Grille
Installation Procedure:
The Installation and servicing of the equipment should be performed by qualified and experienced personnel only.
(a) Stamped Aluminum Grille.
1) Prepare the wall sleeve for installation of the Grille by removing the cardboard stiffener and rear enclosure panel from the
sleeve. These items may be removed from the inside of the room.
Note: -
The Sleeve stiffener must be taken out before the rear sleeve enclosure panel can be removed from the sleeve.
2) Prepare the stamped Aluminum Grille for installation on the sleeve by inserting the six plastic grommets into the square
holes located near the outer edges of all the four sides of the Grille. Now with the Grille positioned so that the flanges of
all the four sides are in the up position (at 90 degrees),
insert the grommets in the opposite direction so that their
square end protrudes through the grille through the
flanges. The Grille is installed in such a way that it could be
removed through the rear sleeve opening.
3) Install the stamped Aluminum Grille by aligning the guide
pins located in the lower right and left hand corners of the
Grille with the corresponding holes in the rear of the wall
sleeve.
4) Secure the Grille by threading each of the screws into the
plastic grommets.
5) Remove the wire handle from the center of the grille prior
to installing the chassis into the sleeve.
Aluminum
AYAGALA01A
Dark Bronze
AYAGALB01A
Soft Dove
AYAGALC01A
Stamped Aluminum Grille
AYRGALA01
and (b) Architecture Grille.