Lexmark MS312, Руководство по обслуживанию

Страница: 32 / 343

–
Have postage stamps attached
–
Have any exposed adhesive when the flap is in the sealed or closed position
–
Have bent corners
–
Have rough, cockle, or laid finishes
•
Adjust the width guides to fit the width of the envelopes.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal
envelopes.
Tips on using labels
Print samples on the labels being considered for use before buying large quantities.
Note: Use only paper label sheets. Vinyl, pharmacy, and two
‑
sided labels are not supported.
For more information on label printing, characteristics, and design, see the Card Stock & Label Guide available
at http://support.lexmark.com .
When printing on labels:
•
Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify that:
–
The labels can withstand temperatures up to 240°C (464°F) without sealing, excessive curling, wrinkling,
or releasing hazardous emissions.
–
Label adhesives, face sheet (printable stock), and topcoats can withstand up to 172
‑
kPa (25
‑
psi) pressure
without delaminating, oozing around the edges, or releasing hazardous fumes.
•
Do not use labels with slick backing material.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial
sheets also contaminate the printer and the cartridge with adhesive, and could void the printer and toner
cartridge warranties.
•
Do not use labels with exposed adhesive.
•
Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or between die
‑
cuts of the
label.
•
Make sure the adhesive backing does not reach to the edge of the sheet. Zone coating of the adhesive
should be at least 1 mm (0.04 inch) away from edges. Adhesive material contaminates the printer and could
void the warranty.
•
If zone coating of the adhesive is not possible, then remove a 2
‑
mm (0.08
‑
inch) strip on the leading and
driver edge, and then use a non
‑
oozing adhesive.
•
Portrait orientation is recommended, especially when printing bar codes.
Tips on using transparencies
•
Print a test page on the transparencies being considered for use before buying large quantities.
•
Feed transparencies from the standard tray, or the multipurpose feeder.
•
Use transparencies designed specifically for laser printers. Transparencies must be able to withstand
temperatures up to 185°C (365°F) without melting, discoloring, offsetting, or releasing hazardous emissions.
Note: If the transparency weight is set to Heavy and the transparency texture is set to Rough in the Paper
menu, then transparencies can be printed at a temperature up to 195°C (383°F).
•
Avoid getting fingerprints on the transparencies to prevent print quality problems.
•
Before loading transparencies, flex, fan, and straighten the stack to prevent sheets from sticking together.
4514-330
General information
32