31
Understanding printer messages
Resetting
Maint Cnt Value
The printer is resetting the counter that tracks wear on the fuser.
Resetting
PC Cnt Value
The printer is resetting the counter that tracks wear on the photoconductor.
Resetting the Printer
Wait for the message to clear.
Res Reduced
The printer is reducing the resolution of a page in the current job from 600 dots per
inch (dpi) to 300 dpi to prevent a
38 Memory Full
error.
Res Reduced
remains on
the display while the job prints.
Restoring Factory Defaults
Wait for the message to clear.
Note:
When factory default settings are restored:
• All downloaded resources (fonts, macros, symbol sets) in the printer memory are
deleted.
• All menu settings return to the factory default setting
except
:
– The Display Language setting in the Setup Menu
– All settings in the Parallel Menu, Network Menu, and USB Menu
Std Bin Full
The standard bin is full.
Toner Low
• Replace the toner cartridge.
• Press
to clear the message and continue printing.
Tray <x> Missing
Insert the tray into the printer.
USB
The printer is processing data through the specified USB port.
Waiting
The printer has received a page of data to print, but is waiting for an End of Job
command, a Form Feed command, or additional data.
• Press
to print the contents of the buffer.
• Cancel the current job.
31 Missing or defective cart.
Insert or replace the toner cartridge.
32 unsupported print cartridge
Install a toner cartridge that is the correct type and capacity for this printer.
34 Short paper
• Load the appropriate media in the selected source.
• To clear the message and print the job using a different paper source, press
.
35 Res save off deficient memory
• To disable Resource Save and continue printing, press
.
• To enable Resource Save after you get this message:
– Make sure the link buffers are set to Auto, then exit the menus to activate the link
buffer changes.
– When
Ready
is displayed, enable Resource Save.
• Install additional memory.
37 Insufficient collation area
• To print the portion of the job already stored and begin collating the rest of the job,
press
.
• Cancel the current job.
37 Insufficient Defrag memory
• To stop the defragment operation and continue printing, press
.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
38 Memory Full
• To clear the message and continue printing, press
.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
Message
Action
