Lexington Forge ASHTON AI31DVC, Инструкция по установке и эксплуатации

Страница: 32 / 44

32
48D0586
CLEANING
AND
MAINTENANCE
Clean the ceramic glass periodically. Condensation will some-
times form on the glass during a cold startup. This is normal for
all gas fireplaces and inserts. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing
of the appliance can also leave a slight film on the glass. This
is a temporary problem.
Your should clean the glass after the first two weeks of use. After that, you should clean the glass no more than two or three times
a season. Use a mild glass cleaner to clean the door. Do not use abrasive cleaners. They will damage the glass surface.
PILOT AND BURNER FLAMES
Visually check pilot and burner flames periodically. See Figure 40 for typical burner flame. See Figure 41 for typical
pilot flame.
Let glass cool before cleaning. Do not
clean glass when it is hot. Damage
could occur.
C
A
U
T
IO
N
Make sure the gas valve knob is in the “OFF” position. Wait at least five (5) minutes before start-
ing maintenance.
VENTING SYSTEM
A qualified agency should examine the venting system annually.
CLEANING GLASS
M a k e s u r e t h a t c l e a r a n c e s t o
combustibles leave enough room for
maintenance and service.
W
A
R
N
IN
G
Carefully reassemble and reseal
insert properly after any cleaning
or servicing.
W
A
R
N
IN
G
FIREBOX CLEANING
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. See pages 22 through 25 .
6. Replace door (if it has been removed).
7. Relight pilot. See page 30.
8. Turn on main burner.
Figure 40 - Typical Burner Flame
Figure 41 - Typical Pilot Flame
Thermopile
Thermocouple