Chapter 12
| Security Measures
Configuring 802.1X Port Authentication
– 346 –
parameters for those ports which must authenticate clients through the
remote authenticator (see
“Configuring Port Supplicant Settings for 802.1X” on
◆
This switch can be configured to serve as the authenticator on selected ports
by setting the Control Mode to Auto on this configuration page, and as a
supplicant on other ports by the setting the control mode to Force-Authorized
on this page and enabling the PAE supplicant on the Supplicant configuration
page.
Parameters
These parameters are displayed:
◆
Port
– Port number.
◆
Status
– Indicates if authentication is enabled or disabled on the port. The
status is disabled if the control mode is set to Force-Authorized.
◆
Authorized
– Displays the 802.1X authorization status of connected clients.
■
Yes
– Connected client is authorized.
■
N/A
– Connected client is not authorized, or port is not connected.
◆
Control Mode
– Sets the authentication mode to one of the following options:
■
Auto
– Requires a dot1x-aware client to be authorized by the
authentication server. Clients that are not dot1x-aware will be denied
access.
■
Force-Authorized
– Forces the port to grant access to all clients, either
dot1x-aware or otherwise. (This is the default setting.)
■
Force-Unauthorized
– Forces the port to deny access to all clients, either
dot1x-aware or otherwise.
◆
Operation Mode
– Allows single or multiple hosts (clients) to connect to an
802.1X-authorized port. (Default: Single-Host)
■
Single-Host
– Allows only a single host to connect to this port.
■
Multi-Host
– Allows multiple host to connect to this port.
In this mode, only one host connected to a port needs to pass
authentication for all other hosts to be granted network access. Similarly, a
port can become unauthorized for all hosts if one attached host fails re-
authentication or sends an EAPOL logoff message.
■
MAC-Based
– Allows multiple hosts to connect to this port, with each host
needing to be authenticated.
Содержание GTL-2881
