Lesco 708686, Руководство оператора

Страница: 4 / 16

4
LESCO
SPECIFICATIONS
OPERATING INSTRUCTIONS
3. Engine Throttle:
Located on the far right side of the control panel
between the handles. Moving the throttle lever
from the front to the rear will increase the engine
speed from slow to fast. To start the engine, set
the throttle all the way to the rear in the “Choke”
position. After the engine starts, move the throttle
halfway between slow and fast.
4. Blade Clutch:
Located on the left handle just below the control
panel. This is an over-center belt clutch and when
the handle is pushed forward until it snaps to rest,
it forces the idler pulley into the blade drive
belt which causes the blades to rotate. When the
handle is pulled back, the pressure on the belt is
relieved and the blades will stop rotating.
5. Ground Speed Control Levers:
Located on the right side of the control panel.
These two levers control the maximum output of
the two hydraulic pumps to the two wheel drive
motors and thus the ground speed of the mower
independent of the engine speed. Moving the right
lever forward increases the output of the right side
pump and moving the left lever forward increases
the output of the left side pump. Normally these
levers are moved in unison. In order to start the
engine both levers must be pulled back to the
neutral position.
6. Traction/Steering Levers:
There is a right-hand lever located beneath the
outer end of the right handle and a left-hand lever
located beneath the outer end of the left handle.
Each lever operates independently and when
A. Controls.
1. Ignition and Start Switch:
Located in the center of the control panel between
the handles. This switch is an automotive key-type
ignition switch and a clockwise 45º turn closes the
ignition circuit. Turning the switch further against
spring pressure starts the engine if the neutral
latch levers are in the neutral lock position, the
ground speed control levers are in neutral and the
blade clutch is disengaged.
2. Fuel Shutoff Valve:
Located on top of the tank in the opening of the
handle mount frame. The handle turns 90 degrees.
When the handle is in a horizontal position, it will
shut off the flow of fuel to the engine. When it is
turned to a vertical position, it will open and allow
fuel to flow to the engine. Anytime the mower is
being trailered or, if the mower will not be in use
for 30 minutes or more, close the fuel shutoff valve
to prevent flooding the engine.
Model: 15/36 17/48 19/52
Engine Mfg: <– – – – – Kawasaki – – – – –>
HP: 15 17 19
Type: <– – – – – 4 Cycle Twin – – – – –>
Starter: <– Recoil –> <– – – – – Electric – – – – –>
Air Cleaner: <– Dual Element Dry –> <– – – – – Heavy Duty Canister – – – – –>
Lube: <– – – – – Pressurized w/Filter – – – – –>
Fuel Capacity: <– – – – – 5 Gallon – – – – –>
Traction Drive: <– – – – – Two variable displacement pumps, two wheel motors – – – – –>
Hydraulic Oil Capacity: <– – – – – 6 Quarts – – – – –>
Hydraulic Filtration: <– – – – – 30 Micron – – – – –>
Ground Speed: <– – – – – 0-6 mph – – – – –>
Wheels: <– – – – – 16 x 6.50-8 – – – – –>
Cut Deck: <– – – – – Fixed – – – – –>
Cut Width: 36" 48" 52"
Overall Width: 47" 59" 63"
No. Blades: 2 3 3
Cut Height: <– – – – – 2"-4" – – – – –>
Deck Material: <– – – – – 10/7 Gauge – – – – –>
Caster Wheels: <– – – – – 9 x 3.5-4 – – – – –>