Lenze MSEMA 063-42 Series, Инструкции по монтажу и включению

Страница: 54 / 80

Mechanical installation
Important notes
•
You must install the product according to specifications in the chapter "standard and operating" condi-
tions.
4
Standards and operating conditions
^
78
•
The technical data and the data regarding the supply conditions can be found on the nameplate and in
this documentation.
•
Observe the information relating to the surface and corrosion protection.
•
Ambient media − especially chemically aggressive ones − may damage shaft sealing rings, lacquers and
plastics. If required, contact your responsible Lenze subsidiary.
Transport
•
Ensure appropriate handling.
•
Make sure that all component parts are safely mounted. Secure or remove loose component parts.
•
Only use safely fixed transport aids (e.g. eye bolts or support plates).
•
Do not damage any components during the transport.
•
Avoid electrostatic discharge on electronic components and contacts.
•
Avoid impacts.
•
Check the carrying capacity of the hoists and load handling devices. The weights can be obtained from the
shipping documents.
•
Secure the load against tipping and falling down.
•
Standing under a suspended load is forbidden.
Preparation
•
Remove protection covers from the shafts
•
Remove corrosion protection from the shafts and contact surfaces (flange/foot)
•
If necessary, remove dirt using standard cleaning solvents
NOTICE
Material damage caused by solvents!
Solvents can destroy bearings and sealing rings.
▶
Bearings or sealing rings must not come into contact with the solvent!
Installation
•
Avoid resonances with the rotational frequency and double mains frequency.
•
The mounting surfaces must be plane, torsionally rigid and free from vibrations.
•
The mounting areas must be suited to absorb the forces and torques generated during operation.
•
Ensure an unhindered ventilation.
•
For versions with a fan, keep a minimum distance of 10 % from the outside diameter of the fan cover in
intake direction.
Dimensions
Dimensions are contained in the configuration document.
Mechanical installation
Important notes
54