Safety instructions
General safety instructions for drive components
11
Lenze ¯ MA 12.0018 ¯ 4.1
Electrical installation
¯
Carry out the electrical installation according to the relevant regulations (e. g.
cable cross−sections, fusing, connection to the PE conductor). Additional notes are
included in the documentation.
¯
The Instructions contain notes concerning wiring according to EMC regulations
(shielding, earthing, filters and cable routing). The compliance with limit values
required by the EMC legislation is the responsibility of the manufacturer of the
machine or system.
Warning:
The inverters are automation components which can be used in industrial
environment according to EN 61000−6−4. These products may cause radio
interference in residential areas. If this happens, the operator may need to take
appropriate action.
¯
Only plug in or remove pluggable terminals in the deenergised state!
Commissioning
¯
If required, you have to equip the system with additional monitoring and
protective devices in accordance with the respective valid safety regulations (e. g.
law on technical equipment, regulations for the prevention of accidents).
¯
Before commissioning remove transport locking devices and keep them for later
transports.
Temperature ranges for gearboxes / geared motors
¯
Standard
0°C ... +40°C
¯
Low−temperature
−30°C .... +10°C
¯
Wide range
−30°C ... +40°C
Information about this can be found on the nameplate (ambient temperature
range and lubricant type) and in the sales documents.
Gearboxes/geared motors are specially optimised for operation within the
temperature range − as specified on the nameplate and in the sales documents.
Operation outside the specified temperature range can lead to increased wear
and even failure.
Disposal
Sort individual parts according to their properties. Dispose of them as specified by the
current national regulations.
