27
E
You have 15 seconds to program the value 93 for activating the
RailCom function into CV7. The LED will shine constantly and
RailCom is activated.
If you want to deactivate RailCom (i.e. disable the blanking interval
(cutout)), proceed as follows:
Change to "PoM"
Select CV7
Program the value 50 into CV7. This switches the
LZV100/LZV200/LV103 into setting mode; again, the LEDs show a
double-flash.
You have 15 seconds to program the value 92 for deactivating the
RailCom function into CV7. Again, the LED will shine constantly
and RailCom is deactivated.
10 The LED display
The various operating statuses of the LV103 are indicated by the LEDs
on the front plate:
LED shines constantly Everything ok, device in normal operation
LED flashes slowly
Terminals C and D are not connected
or
Emergency stop, track voltage switched off at
an operating device
or
The command station is not ready for
operation
LED flashes quickly
Emergency stop, track voltage switched off
or
Overheating of amplifier
LED double-flashes:
A programming procedure was started by
means of PoM (see “Setting the track
voltage”)
