26
Information LV103
The following chart shows which value you have to program in CV7 to
set a certain current value at the output:
current (A):
Value in CV7:
2,5
5
3
6
3,5
7
4
8
4,5
9
5
10
To use a 3A transformer, please set a maximum current on the
track of 3A.
9 RailCom: Activating the cutout in the LV103:
Important Note: RailCom is enabled in the factory default setting!
Use "PoM" ("Programming in operational mode") to activate RailCom.
Before making any settings, familiarise yourself with PoM practices in
combination with the manual control LH100 or LH90. When activating
the RailCom function, the LZV100 must be switched on.
The following procedure activates the blanking interval (cutout) both in
the amplifier component of the LZV100/LZV200 as well as in the each
of the LV103/LV102 amplifiers that are connected to the terminals
CDE of the LZV100/LZV200.
When using a command station LZ100 (from software version 3.5),
you will use this command station to activate the blanking interval
(cutout) in the LV103 amplifiers that are connected to the terminals
CDE.
Proceed as follows:
Select any locomotive address on the manual control.
Don’t worry:
If a locomotive with the selected address is placed on the track
during activation, its settings will not be affected because CV7 can
only be read but not changed.
Change to "PoM"
Select CV7
Program the value 50 into CV7. This switches the
LZV100/LZV200/LV103 into setting mode; the LED of the
LZV100/LZV200/LV103 shows a double-flash.
