Lenovo ThinkSystem ST50 V2, Руководство по обслуживанию

Страница: 75 / 192

• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Step 1. Make preparation for this task.
a. Remove the server cover, see “Remove the server cover” on page 143 .
Note:
The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
b. If applicable, remove the optical drive, see “Remove an optical drive” on page 70 .
c. Remove the optical drive cage, see “Remove the optical drive cage” on page 75 .
d. If applicable, remove the 3.5-inch drive from the 3.5-inch drive cage, see “Remove a simple-
swap drive (bay 3)” on page 62 .
Step 2. Remove the 3.5-inch drive cage from the optical drive cage.
a. Remove the screw that secures the 3.5-inch drive cage to the optical drive cage. Reserve
the screw to be used for reinstalling the 3.5-inch drive cage..
b. Slide the optical drive cage to separate it from the 3.5-inch drive cage.
Figure 49. Removing the 3.5-inch drive cage from the optical drive cage
After you finish
1. Install a new 3.5-inch drive cage, see “Install the drive cage (bay 3)” on page 67 .
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the drive cage (bay 3)
Follow this procedure to install the drive cage to bay 3.
Chapter 3
.
Hardware replacement procedures
67