Lenovo ThinkSystem ST50 V2, Руководство по обслуживанию

Страница: 160 / 192

Step 2. Secure the system board to the chassis with nine screws in the sequence shown on the illustration
below.
Figure 122. System-board screws installation sequence
After you finish
Note:
Make sure the CMOS battery is installed on the system board, see “Install the CMOS battery
(CR2032)” on page 47 .
1. Reinstall the processor. see “Install the processor (trained technician only)” on page 135 .
2. Reinstall the heat sink and fan module, see “Install the heat sink and the fan module (trained technician
only)” on page 96
3. Reinstall the memory modules. see “Install a memory module” on page 112 .
4. Reinstall the front panel, see “Install the front panel” on page 90 .
5. If necessary, reinstall the PCIe adapters, see “Remove a PCIe adapter” on page 119 .
6. If necessary, reinstalled the M.2 drive, see “Install an M.2 drive” on page 105 .
7. If applicable, reinstall the rear fan, see “Install the fan (front and rear)” on page 81 .
8. If applicable, reinstall the cage bar, see Step 1 in “Install the server cover” on page 146 .
9. If necessary, reinstall the optical drive cage, see “Install the optical drive cage” on page 77 .
10. If necessary, reinstall the optical drive, see “Install an optical drive” on page 72 .
11. Reinstall the front bezel, see “Install the front bezel” on page 85 .
12. Reconnect all the cables that were disconnected.
13. Complete the parts replacement, see
“Complete the parts replacement” on page 158 .
14. Update VPD. See “Update VPD (Vital Product Data)” on page 153 .
15.
Important
Update the system firmware and device driver.
• Go to https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/st50v2/downloads/
driver-list/
to see the latest firmware and driver updates for your server.
• Go to “Update the firmware” on page 8 for more information on firmware updating tools.
152
ThinkSystem ST50 V2 Maintenance Manual