Lenovo ThinkSystem ST50 V2, Руководство по обслуживанию

Страница: 117 / 192

Install the M.2 drive retainer
Follow this procedure to install the M.2 drive retainer.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read “Safety inspection checklist” on page iv and “Installation guidelines” on page 41 to ensure that you
work safely.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
After you finish
Step 1. Align the M.2 drive retainer with the three slots on chassis, and lower the retainer into the chassis;
then, slide the retainer toward the 2.5-inch drive to secure it in place.
Figure 87. Installing the M.2 drive retainer
After you finish
1. Install an M.2 drive, see “Install an M.2 drive” on page 105 .
2. If necessary, reinstall the 2.5-inch drive to the drive bay 2, see “Install a simple-swap drive (bay 1-2)” on
page 53 .
Chapter 3
.
Hardware replacement procedures
109